Palm TX Motherboard Replacement

Автор: Spencer Lewson
  • Комментарии: 1
Palm TX Motherboard Replacement

Сложность

Moderate

Шаги

8

Необходимое время

10 - 15 минут

Введение

This guide will walk you through the steps to remove the motherboard on a Palm T|X.

  1. SFqUJpIxgUDWqMDg
    SFqUJpIxgUDWqMDg
    eScJPtslX1VtsP5Z

    • Orient the device so that the display faces forward.

    • Remove the stylus from the right side.

  2. cU3agxDMnT5RnWAM

    • Turn over the device so that the back panel faces forward.

    • Use a T5 Torx screwdriver to remove the four 6.35mm corner screws.

  3. xfoRukNaUfI1RLXB
    xfoRukNaUfI1RLXB
    K2hSQNYTu2BmokBO

    • Rotate the device so that the display faces forward.

    • Insert a plastic opening tool with the angled tip pointing downward into the crevice on the left side of the device.

    • Pry along the crevice to loosen the back panel.

    • Repeat this process for the right side.

  4. RVnJ6LRyWDeAW2Bq
    RVnJ6LRyWDeAW2Bq
    adjBVeEfOplaNhMp

    • Carefully pry the back panel to open the device.

    • Be careful not to break the wire that connects the battery pack to the motherboard.

    • When reassembling, snap the back panel back into place and then insert the top cover.

  5. mKT1vZ2xqFrEwSUs
    mKT1vZ2xqFrEwSUs
    RByTDfhlQgNr6HNZ

    • Use a plastic opening tool to peel the battery pack from the back panel.

    • The battery pack is glued to the back panel so removing it may require considerable effort.

  6. FQW1IOAbK6pZSIwD
    FQW1IOAbK6pZSIwD
    mucXYAiugnNA6YgE

    • Use a soldering iron to disconnect the battery wires from the motherboard.

    • For soldering instructions, you can view the Soldering Guide.

  7. MDYNhMlOdw1FYrhS
    MDYNhMlOdw1FYrhS
    6Jm2UCEGM2tA13ko

    • Pull straight up on the ribbon cables located on the bottom right of the motherboard to disconnect them.

  8. W4h51fDyuFUaAvUF
    W4h51fDyuFUaAvUF
    PSLnK1yivGkKDhyg

    • Lift the mother board out of the device.

    • A weak adhesive attaches the motherboard to the device.

    • The red wire in the picture will not be attached to your device at this point.

Заключение

To reassemble your device, follow these instructions in reverse order.

Автор

Spencer Lewson

Участник c: 19/01/11

793 Репутация

Один комментарий

Nicely done!

Matthew Newsom -