Makita Jack Hammer HM1203C 2010 Carbon Brush Set Replacement

Автор: Adam O'Camb
  • Комментарии: 0
Makita Jack Hammer HM1203C 2010 Carbon Brush Set Replacement

Сложность

Moderate

Шаги

5

Необходимое время

5 - 20 минут

Введение

Use this guide to replace the motor brush set in the Makita Jack Hammer HM1203C 2010.

  1. 1tQ4rEpfJXZA1NYl

    • Make sure the hammer is disconnected from power before beginning any repair.

    • Use a Phillips #2 screwdriver to remove the three screws securing the motor cover.

  2. U2L2NPNyCs62USnK
    U2L2NPNyCs62USnK
    YgbRnmBUVWvwict1

    • Remove the motor cover.

  3. uiH2nACAxbq5c1EQ
    uiH2nACAxbq5c1EQ
    VIusLqr1cKXwMnmV

    • Pull the brush connector straight off of its spade to disconnect the brush.

  4. N2AHgntisKWLuacS
    N2AHgntisKWLuacS
    MuIJvJbE15DpCOug

    • Use a pick or small flathead screwdriver to pull the brush retaining spring off of the brush.

  5. sPAXcLpQdZlTf2mJ

    • Lift the brush out of its motor housing while holding the retaining spring out of the way.

    • Repeat the last three steps to remove the second brush.

Заключение

To reassemble your device, follow these instructions in reverse order.

Автор

Adam O'Camb

Участник c: 11/04/15

211971 Репутация

0 комментариев