Disassembling Breville BKC600XL Bottom Covers

Автор: Antonio
  • Комментарии: 0
Disassembling Breville BKC600XL Bottom Covers

Сложность

Moderate

Шаги

4

Необходимое время

10 - 15 минут

Введение

This guide acts as a prerequisite for removing or replacing any part located inside the main body of the brewer.

Инструменты

  1. j3hn3JoNAdyyp3B5
    j3hn3JoNAdyyp3B5
    WiPcxUaiGIxHtSQ1
    pbvbojSKRsYOFBNN

    • Use a Phillips #0 screwdriver to remove the following ten screws:

    • Four 18mm Phillips screws.

    • Four 9.75mm Phillips screws.

    • Two 8mm Phillips screws.

    • The cover will not remove entirely. Keep green ground wire attached to the cover.

  2. jGd1YD5mKWKJw1uP
    jGd1YD5mKWKJw1uP
    iJF5HsIgmYifl5TA

    • Remove the two 14.5 Phillips screws.

    • Ensure that only the water inlet valve can be moved.

  3. 2LaQKUV6pmScZAmV
    2LaQKUV6pmScZAmV
    p5mAbee5SXTQqaRo

    • Use a Phillips #0 screwdriver to remove the following six screws:

    • Six 14.5mm Phillips screws.

  4. aHhWgDlgVJSQ2KVo
    aHhWgDlgVJSQ2KVo
    jmjjOleFJloSh15a

    • Remove the power cord from the groove. (the black cord that leads into the green wire.)

    • This creates more slack in the wire to give you more room to work with.

    • DO NOT remove green wire from the cover its attached to.

Заключение

To reassemble your device, follow these instructions in reverse order.

Автор

Antonio

Участник c: 26/09/12

135 Репутация

0 комментариев